Here is a mini guide on how coal in a mover can be serviced or replaced.
These photos are from another project but gives you perhaps inspiration on how to change coal into a mover and troubleshoot, service. 🙂
A mover electric motor is quite simple since the case of an electric drive motors, where coal and commutator are some important parts of an electric motor.
Very coal dust in the brush holder can prevent the coal from moving freely.
It can prevent the coals in, optimal contact with the commutator, and it can restrict the flow thus result in a lack traction (Sluggish mover).
If your mover has a lack of traction (Sluggish mover), you can take the coal out, When the coals are out, gently blow holder clean of any. kulstøv. Once you've done it, make sure, that coal can move freely up and down the brush holder before you collect your mover again.
The above is worth trying before buying new coal.
If the coal stuck in the brush holder, it may be due to “goop” (coal dust mixed in the condensation).
Typically, it can occur in winter campers who often use their mover in winter, which can eventually lead to poor contact between the commutator and brushes due to coal dust mixed in the condensation. Condensate comes using mover in winter, and the combination of pulverized coal and condensed water is a poor mixing of the coal with an electric motor. There may also be additional coal dust in the engine at any. overloading mover, or coal be broken.
If your mover has poor or suddenly not working, above can be the cause, and a treatment for any. sweepings should be.
Her kan du se en Truma Mover SE fra 2008, where the plastic cover that protects the engine is removed, and you see the pole to move the coal is not completely clean. (The following images can be enlarged by clicking on the picture).
Make sure that the cable terminals are clean, Thus, there is a good connection.
After you have cleaned the brush holder and cleaned coil for dirt and ir, make sure the coal can move freely in the brush holder. Can coal move freely in the brush holders can collect it all again 🙂.
If you change the carbon in your motor mover, you should change all coal in the engine to replace coal.
The picture below is a picture of coal at a mover.
|Some tips to ensure good 12 volt connection:|
|All terminals in the installation checked, they must not be loose or corrosive.|
|cable / ends must be kept clean. Ir / oxidation may not occur.|
|Check all connections for clamping and corrosion.|
|Connections and fuses should be kept clean also converter board.|
|Battery terminals should be clean and free from corrosion. They should be shielded so there can be no short circuit.|
If relevant links
Caravaninfo.dk can not be held responsible for the use of ovenståenden information. Likewise, it is the respective user who is responsible for the then legislation in force for the export of 12 Volt..
NB. Remember to participate in the vote, You can also write your possible. comments / experiences at the bottom.
click here – Link to the polls together